Place Hole Circles

When you select a profile plane, the command bar automatically advances to the profile step, and the following changes take place:

• The profile true view is displayed. You are not limited to the true view for drawing the profile you can draw the profile in any view.

• A drawing command toolbar is displayed. For hole features, the Hole Circle command is available to construct the hole profile. You can use the Line, Arc, Circle, and Rectangle commands on the toolbar to create construction geometry for the hole profile. To draw holes that are not circular, use the Cutout command.

• The command bar changes to a Profile command bar. For hole features, the options on this command bar are related to setting hole circle parameters.

Draw one or more hole circles, and then click the Finish button on the command bar. If the hole circle profile is invalid for constructing the hole feature, you are returned to the profile step. A message describing the problem is displayed. When you have corrected the problem, click Finish again to proceed.

---